- Equipment
- Instruments
- Furniture
- Chemicals
- Supplies & Consumables
- Safety & Apparel
- Thomas® Brand
- Clearance
- Browse By
For Customer Service Call 1.800.345.2100 International Sales
Delivering Quality Scientific Supplies Worldwide Since 1900
TLC Plates
EMD Millipore
Glass TLC Plates
For thin layer and preparative layer chromatography Ready-to-use Layer thickness 0.25 mm Allow safe spotting without layer damage Plates have a uniform, abrasion-resistant coating and a patented, inert, hard-layer binder that is chip and abrasion-resistant. F254 is a…
EMD Millipore
Cellulose plates (TLC and HPTLC)
SPECIAL OFFERS: Rediscover TLC: Buy 3 packs of ANY EMD TLC plates and receive a FREE UV lamp or ready-to-use spray solution (up to $112 savings!) or Buy 6 packs of 1.15341.0001 (1205Q10) and receive a FREE TLC sprayer ($705 savings!) SeccoSolv® and TLC: Buy a box of EMD Millipore TLC…
Avantor – J.T.Baker®
Pre-Coated Glass Hard Layer Silica Gel TLC Plates
Vacuum-sealed plates exclude moisture and have a convenient hard surface for writing Silica gel with inert binder Each channel is approximately 8 mm wide with 1 mm spacing between channels Plates have 250 µm analytical layer, except for 0144K71 plates which have a 200 µm analytical layer.…
Thomas®
Thomas Glass Sprayer
Provides uniformly fine mist or spray, required for paper chromatographic determination Conveniently located vent permits instantaneous control of spray Borosilicate glass tube has permanently attached, molded phenolic screw cap (size No. 24) with polyvinyl liner which fits commercial…
Kimble
TLC Reagent Sprayers
Provides a uniform spray mist of visualization reagents for both thin layer and paper chromatography Borosilicate glass Handles all standard TLC spray reagents and most corrosive liquids Creates consistent spray patterns that are free of damaging droplets The connection between the sprayer…
General Glass Blowing
10 cm Developing Tank
Flat ground top is beveled on the inner and outer rim Ground flat bottom for stability Holds two 10 x 10 cm plates or four 5 x 10 cm plates Thin-Line units allow for faster and more uniform solvent saturated atmosphere and therefore require less solvent. Inside dimensions: 12 x 6.4…
EMD Millipore
TLC Silica gel 60 F254
EMD Millipore classical silica TLC plates are based on a combination of proven EMD Millipore silica gel 60 and the addition of a unique polymeric binder resulting in a very adherent and hard surface that will not crack or blister and even allow writing with a pensil on the surface without risk to…
General Glass Blowing
10 cm Latch-Lid Chromatotank
Requires less solvent to maintain equilibrium Gives excellent retention of solvent saturated chamber Holds two 10 x 10 cm plates The smaller cubic inch chamber allows for a faster and more uniform solvent-saturated atmosphere. Single molded tank has a flat ground top, beveled for…
Avantor – J.T.Baker®
Baker-flex® Coated TLC Silica Gel Sheets
Ready-to-use plastic sheets, 50 x 200 mm or 200 x 200 mm, with absorbent coating, which is abrasion-resistant and highly uniform; are easily cut to desired size and allow sample fraction to be cut rather than scraped The silica gel and aluminum oxide sheets have coating approximately 200 microns…
General Glass Blowing
Rectangular Developing Tank
Beveled inside and outside to remove any sharp edges Raised ridge midway on the inside ends and bottom for developing two 20 x 20 cm plates or the equivalent Inside dimensions: 27 x 7 x 26 cm Supplied with flat glass lid, 30 x 10 x 3 cm Molded glass block of clear glass with…
Kimble
TLC Developing Tank
Constructed of sturdy molded glass bricks Withstands regular use for many years The tank’s clear sides allow for visual inspection of TLC plates up to 20 x 20 cm size. The top of the tank is ground flat to match the lids and the edges are beveled to remove any sharp edges. The bottoms are…
EMD Millipore
HPTLC Silica gel 60 F254 Premium Purity
The plate is highly pure and exhibits minimal background, even with middle-polar solvent systems. Ideal for advanced pharmacopoeia applications, this high-performance plate keeps separations free of contamination. Its separation performance is an exact match to the related HPTLC plate product.…
General Glass Blowing
Latch-Lid Chromatotank Unit
Clear glass sides allow unobstructed visual inspection of contents Tank is ground flat to match ground glass lid. Beveled inside and outside to remove any sharp edges. Holds two 20 x 20 cm plates or four 10 x 20 cm plates. Latching device holds the matching ground glass surfaces of the lid…
EMD Millipore
TLC Aluminium oxide 60 F254, basic
Aluminiumoxide plates are used to analyze basic and neutral compounds at different pH levels. Depending on the pH range in question, professionals can choose between two kinds of aluminum oxide plates. Under aqueous conditions, basic aluminum oxide plates are best for separating basic compounds,…
EMD Millipore
TLC Silica gel 60 F254
Classic silica TLC plates are based on a combination of proven EMD Millipore silica gel 60 and the addition of a unique polymeric binder resulting in a very adherent and hard surface that will not crack or blister and even allow writing with a pensil on the surface without risk to damage the layer.
Corning
Corning® High-Content Imaging Glass Bottom Microplates
High optical-quality glass bottom, black microplates are ideal for performing high-content cell-based assays using imaging systems. The glass bottom provides a flat and optically clear surface that reduces autofocus time, increases throughput and is ideal for cell growth. High optical quality…
EMD Millipore
HPTLC Cellulose
Cellulose plates are used to analyze polar substances. An organic sorbent, cellulose is perfect for separating hydrophilic substances by partition chromatography. Typical applications include the analysis of amino acids, carbohydrates, and phosphates as well as nucleic acid and nucleic acid…
EMD Millipore
TLC Silica Gel 60 F254 Multiformat Pre-scored to 5 x 10 cm
Pre-scored glass plates fold into smaller formats with just one easy snap of the fingers. HS Code: 3822 00 00
EMD Millipore
PLC Silica Gel 60 RP-18 F254s, 1 mm
PLC plates allow users to separate samples that vary greatly in size – from grams down to milligrams. Available with or without a fluorescence indicator, PLC plates has 1mm thickness. They also use the same proven EMD Millipore silica-binder technology as in analytical TLC plates. To isolate the…
GE Healthcare
TLC Plate
Partisil K6 60Å and K5 150Å TLC plates provide a choice of high-purity silica gels with polarity for normal phase separations. They provide enhanced performance compared to silica gel 'G' through better resolution, higher sensitivity and more durability. Moderate layer hardness makes possible…
EMD Millipore
TLC Silica Gel 60 F254 GLP
These plates feature individual laser coding for GLP applications. Designed for GLP applications, the tops of each of these plates bear an item, batch, and individual plate number. As a result, lab professionals can easily record and archive every plate they use. Based on proven EMD Millipore…
EMD Millipore
HPTLC silica gel 60
HPTLC plates deliver fast and quantitative analysis of complex samples for manual or automated use. EMD Millipore’s HPTLC silica plates work three times faster than conventional TLC plates – and they’re more sensitive. The particle sizes range in HPTLC is between 4-8µm, which creates a…
EMD Millipore
TLC Silice gel 60 NH2 F254s
Our NH2, CN and DIOL -modified silica sorbents are less polar then conventional silica phases, making them ideal for separating hydrophilic or charged substances. Our moderately polar cyano- and diol-modified silica plates can be used for both normal phase and reversed phase systems. An…
EMD Millipore
HPTLC Silica gel F254 GLP
Features individual laser coding for GLP applications. Designed for GLP applications, the tops of each of these plates bear an item, batch, and individual plate number. As a result, lab professionals can easily record and archive every plate they use. Based on proven EMD Millipore silica found in…
EMD Millipore
HPTLC Silica gel 60 RP-18
RP modified plates serve two purposes: act as a pilot method for HPLC and allow to choose various solvent system for special separations. RP-modified silica layers from EMD Millipore are well suited for many separation challenges that unmodified silica cannot overcome. These layers use aqueous…
EMD Millipore
HPTLC Silica gel 60 DIOL F254s
Our NH2, CN and DIOL -modified silica sorbents are less polar then conventional silica phases, making them ideal for separating hydrophilic or charged substances. Our moderately polar cyano- and diol-modified silica plates can be used for both normal phase and reversed phase systems. An alternative…
EMD Millipore
HPTLC Silica gel 60 F254 GLP
These plates feature individual laser coding for GLP applications. Designed for GLP applications, the tops of each of these plates bear an item, batch, and individual plate number. As a result, lab professionals can easily record and archive every plate they use. Based on proven EMD Millipore…
EMD Millipore
HPTLC Silica gel 60 F254
Plates deliver fast and quantitative analysis of complex samples for manual or automated use. EMD Millipore’s HPTLC silica plates work three times faster than conventional TLC plates – and they’re more sensitive. The particle sizes range in HPTLC is between 4-8µm, which creates a smoother…
 |
 |
 |
 |
 |
 |
Site Search by
Back To Top
- We Believe You Are Important - How Can We Help?
Thomas Scientific is a Small Business, EEO supplier ©Thomas Scientific 2013